user 'robert' has been very busy converting all my sketches into superb drawings so this will be the place for lots of wiring diagrams:
1. using the 'action electronics' dual-esc with 3 motors:
the diodes make the inner motor run when going forward (with 1,4 volts less than the outer motor with the higher voltage level). also they prevent the esc from being destroyed by the 'connected' outputs. a standard 5amps diode will do...
if the voltage doesn't exceed 1,5 volts there's no need for using diodes and microswitches + removing servo notch. (servo motor has not enough power to destroy gearbox or notch then). so the notch can be used to stop servo movement. this voltage limit can be achieved by either using a single cell or mini-esc with some resistors (see no. 4)
Jimbo: Hello Mark, Is the season over for the Build the Bismark later bloomers. Am having trouble getting help on parts for issues 47 thru 140 after checking out Ebay and other sites.Know where I might get some help. Thanks James
Jul 28, 2014 14:27:47 GMT 1