|
Post by russ on May 22, 2010 22:29:36 GMT 1
Ok heya guys, well the Bissy has been stood for some time now but due to the heat here ive been able to sit ina cool room all day and work on it. Taken all day but i have managed to bore the holes out for the Prop tubes, build up one of the motors ready to Fit. And a little bit of brass (not shown here)
|
|
|
Post by mike on May 23, 2010 19:43:39 GMT 1
Hi Russ your bissy is comeing along nicely, is that a couple of Chill's dancing girls standing on your shelf, have a K for your effort.
mike
|
|
|
Post by russ on May 23, 2010 21:19:23 GMT 1
thanks Mike, yes it is a couple of chills dancing girls, though one isnt very friendly she has a meat knife behind her back
|
|
|
Post by russ on Aug 26, 2010 22:08:13 GMT 1
Right okay then dedided today that sems as my bikes are comign back together nicly, the Land Rover done and on the road and my #RC Car is all done that the bissy should come off the shelf. First task was the mamouth task of dust clearence once done i have Glued both motor mounts in place, and started to use the Epoxy Putty that mark sugested from games workshop to nicly mold around the prop tubes insude and make a start n coverign up the huge holes been made. Will continue with the putty tomorrow night once that motor mount has dried fully, then will be fittign the Ruddrs into place
|
|
|
Post by russ on Dec 12, 2010 18:33:45 GMT 1
Beena while things just wasnt going to plan with the build so left for a while, tried my hand at the Waterlien today slightly wrong as it either sloped up or down but i carnt quite see, not to worry a handy home made tool will help when the paint is dry tomorrow
|
|
|
Post by eric on Dec 16, 2010 15:29:54 GMT 1
Nice to see you making good progress Russ!
Will you be opening out the second line of hull scuttles?
|
|
|
Post by russ on Dec 16, 2010 18:12:28 GMT 1
Yes i shell Eric ive only dont a small area so far as that is all i have prepaired,
|
|