|
|
Post by popeye on Sept 18, 2009 4:08:16 GMT 1
|
|
|
|
Post by paulhbell on Sept 18, 2009 12:49:42 GMT 1
Looking good. Have you had any problems with the gears meshing. My big Sun gear turns about 350 degrees, then sticks for about 10 degrees. It's not bad, just a bit tight.
|
|
|
|
Post by popeye on Sept 21, 2009 9:13:07 GMT 1
Dear Paulhbell
I had a similar problem at the start which seemed to be due to holding the gear tightly down against the frame when tightening the grub screw, so that there was little/no play on the shaft. I loosened the grub screw and eased the gear up a smidgeon and on retightening, the gear run fairly smoothly all the way round.
|
|
|
|
Post by eric on Sept 22, 2009 22:35:24 GMT 1
Looks great Popeye, you just need to polish out some fingerprints there!!!
|
|
|
|
Post by popeye on Nov 8, 2009 4:37:51 GMT 1
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Nov 8, 2009 4:54:01 GMT 1
Looking good. I'm waiting for Jcmanu for my next lot of issues.  |
|
|
|
Post by paulhbell on Nov 8, 2009 11:31:06 GMT 1
Good to see your getting your issues. Still waiting for mine.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on May 7, 2010 2:00:23 GMT 1
Any more progress.  |
|
|
|
Post by popeye on May 10, 2010 13:25:11 GMT 1
Dear Skyfire
Yes, all is complete and set up according to the instructions. I have taken photos (including in the dark with the sun lit up, although it is difficult to see it well on a photo) and will post these shortly - I am still busy with the new workshop, we are fitting the 15 spotlights to properly light all the work areas, the sink with hot and cold water in the winery is fitted. The beech effect floor boards are purchased, ready to lay down.
|
|
