|
Post by jason on Jan 8, 2009 20:41:13 GMT 1
Hi all, just got back round to my build after a break from building. Got up to issue 77 and come up against a problem on pic 2 part 658. When i place it between the 2 side pieces and try to fit part 660 ( pic 04 ) it just does not sit flush as part 658 ( the end with the 2 tiny holes ) is too high and not flush
Where have i gone wrong, and how did you overcome the problem.
Jay
|
|
|
Post by matt on Jan 12, 2009 19:51:28 GMT 1
I had a little trouble with this part. I had a problem with part 657 photo 02. I had not fitted it correctly as shown in photo 03. It fits on the outside of the jaws of 656 and 659. I had fitted it on the inside. When I corrected it if everything is squared up 660 should go over 658 and with a bend near the top fit on top of 656 and 659. It all worked out. Hope that helps if not please pop a photo on and perhaps we can see what has gone wrong.
Matt
|
|
|
Post by jason on Jan 12, 2009 21:27:58 GMT 1
Cheers for the reply will get a look at it again tommorow after work.
|
|