pod
New recruit
Posts: 3
|
Post by pod on Nov 25, 2007 8:53:31 GMT 1
Hi all, I have a question regarding part 47 from issue 9, it's for the rudder servo mounting, one side of the part is wider than the other, but the instructions don't say which way it should go in. Is there a right way or a wrong way for it, and which way did most of you opt to go with it?
|
|
|
Post by Mark on Nov 25, 2007 9:59:15 GMT 1
Hi Pod,
I don't think it's going to matter as there is always a good deal of adjustment in the rudder push rods. However, you could just leave it out until later. It will be easy to install just before you install the rudder. That's what I'm doing.
|
|
|
Post by Smackmback on Nov 29, 2007 12:56:58 GMT 1
Pod, Shawry here. I think if you study the photos closely especially inissue #10 photo #3 you will see that the wider part seems to be towards the bow so as to clear the ribdirectly below that inside edge of the mount plate. There are a few photos and to me they all look like they are indicating that the wider part is forward. Correct me if I am wrong anybody but thats what it looks like to me. It is to clear the rib .....put some thing square up to see the clearances. Cheers ROB
|
|