|
Post by valleydweller on May 29, 2007 17:29:48 GMT 1
Now remember everyone that I'm new to this What are the handiest tools you have for making these models? Is it essential to build a jig for holding the hull? If you could give me 1 piece of advice (about building the Bismarck ;D), what would it be? Should I go wet or dry? And if I should go wet what is the most reasonable cost to go to for a full R/C kit? Thanks all Dean
|
|
|
Post by napoleon on May 29, 2007 19:51:37 GMT 1
I'm new also to this but from what I have read on various sites, laying out the keel on a board, definately keeps the hull construction dead straight and I have seen the benefits of this. I am going for a Display only version, wife wont let me spend much more on this model! lol
|
|
|
Post by Mark on May 30, 2007 1:59:54 GMT 1
Hi Dean, Tools - I don't use expensive tools (very often ) A couple of craft knives, one big one small. A steel rule is essential. A square of some sort - CD cases are OK, but a proper square is easier to use. Also get a sanding block and a selection of sandpaper. I use a flat block of wood about 2x3" which I rescued from a scrap bin. A sanding block is also essential. Using sandpaper in your hand makes for an uneven surface. ! piece of advice ? Take your time. Measure twice, cut once as carpenters say. A building jig ? It certainly makes building a straight hull easier. The only place where I would say it is essential is at the stern. All that is needed is a centre line drawn on the building board, and use a couple of square brackets to hold the stern straight and upright. You can use shelf brackets for this, they aren't expensive and are easy to screw to the board. R/C or not ? Entirely up to you..... You will have to make some compromises to the scale appearance if you go RC. E.g. Working rudders, props and shafts will not be true to scale.
|
|
|
Post by swanrail on May 31, 2007 0:01:08 GMT 1
I also use: needle files (but not till later), various clips/clamps (see my tip entry), a hacksaw blade (without frame) used to cut out awkward bits (as I have done for 3rd. motor r/c control), I also have been using brass plated pins (from Titanic) to hold planks in place while glue sets. Other models I have used map pins (have large plastic heads) but here found planking material too hard. A pin hammer (to use on nails above) and a pair of pliers to pull them out when glue set (only nail in halfway). I also use an old computer desk as a workshop, fitted with model makers vice (not yet used), with a magnifying glass/light assembly "purloined" from my wifes sewing box. This is about 3 ft high and has a swinging arm to b#get over what ever is necessary. Expect this to come into its own when we reach the Fiddly bits! Brass weights nicked from kitchen to hold parts in position while glue sets. Evostick weatherproof wood adhesive (quick drying).
|
|