Resin part D error

ian39
Cabin boy

Posts: 8

Resin part D error Jan 1, 2013 21:43:28 GMT 1

Quote

Post by ian39 on Jan 1, 2013 21:43:28 GMT 1

Bit far behind, but I was checking the fitting of resin part D. (issue 36} and found it about 2mm too high and noticed in issue 12 that I put parts 58 too high. D'oh. I can't think of a way to take these parts of and re-do it. Only thing I can think of is to try and sand these parts down carefully so I don't sand down any of the second layer of planking. Craft knife might also help me here.

Just hoping if anyone else has any ideas about fixing this error I did.

I can't believe I done something so stupid.

Deleted Deleted Member Posts: 0	Resin part D error Jan 4, 2013 22:11:04 GMT 1 Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by Deleted on Jan 4, 2013 22:11:04 GMT 1 If you used pva, you can use a damp sponge to soak it and the parts will come off. Take it slow and easy.

ian39 Cabin boy Posts: 8	Resin part D error Jan 7, 2013 18:41:10 GMT 1 Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by ian39 on Jan 7, 2013 18:41:10 GMT 1 The glue I have been using for the wood is Evo-stik wood adhesive. Not sure if this is pva.

Jimbo: Hello Mark, Is the season over for the Build the Bismark later bloomers. Am having trouble getting help on parts for issues 47 thru 140 after checking out Ebay and other sites.Know where I might get some help. Thanks James Jul 28, 2014 14:27:47 GMT 1

Post by ian39 on Jan 1, 2013 21:43:28 GMT 1

Post by Deleted on Jan 4, 2013 22:11:04 GMT 1

Post by ian39 on Jan 7, 2013 18:41:10 GMT 1

Shoutbox