|
Post by afkmatrix on Apr 13, 2008 16:57:34 GMT 1
Ok i am ready to attach the bow resin piece but have noticed it is not square. So the front will slope up slightly, is this correct? Do i need to square this piece up?
|
|
|
Post by eric on Apr 13, 2008 17:42:31 GMT 1
Hi matrix, do not sand it square, it has a natural rise that continues the hull flare, if you sand it, or put it on too low, the bows will loose that continuity.
What i did was to glue on the wooden part above it first, leave it to bond overnight (epoxy resin), then glued on the bow, ensuring I had firmly pushed it under the wooden part to the point where it actually raised to very front of the wooden part up.
|
|
|
Post by afkmatrix on Apr 13, 2008 18:53:24 GMT 1
Thanks for the info Eric. Will have to do this tomorrow then as I am in the delicate process of modding my rear part 70 resin peice as I have cut this up and am glueing a delicate piece at the mo.
|
|